{"ok":true,"content":"Hello.<br><br> Thank you for the quick help!<br><br> Channel assignment is working.<br><br> Unfortunately, USB is not yet being recognized correctly.<br> Heli turns on, software starts, and USB is connected, but it doesn&#39;t work.<br><br> It needs to be disconnected from the power supply via USB connection before it works...<br><br> I would have finished the setup if it weren&#39;t for the external controller!<br> Basically, the whole thing already works.<br> But there is a slight uncertainty.<br><br> I also have a Kosmik cable and would like a pass-through option.<br><br> The stabilizer only needs the engine to turn on and off, OK.<br> Then I could plug it into the receiver and program my transmitter as normal.<br><br> Do I really have to throw out the RSat and install a normal receiver?<br> Am Sat only has Ext for Teletubbies and PPM for UDI!<br><br> I don&#39;t like the way I&#39;ve solved it at all.<br><br> 3-step switch SB is motor signal, Off, Idle and On.<br> Sa is additionally engine off<br> And the slider 5 on the right side is for switching banks.<br> Then the engine speeds change, and whether that will work well in the long run... I don&#39;t think so!<br> I also don&#39;t want to switch AR via a 3-way switch...<br><br> I would like to have SA Motor On and Off<br> Press the SG (spring switch) once to activate Idle, and press it again to deactivate Idle.<br> and on SB the bank switching and thus 3 speeds.<br><br> How do I achieve that?<br><br> Hoping for other Yeti users.<br><br> Regards, Christian","note":"machine-translated from German"}