{"ok":true,"content":"Hello.<br><br> I urgently need help!<br><br> I received a Neo without Vlink yesterday.<br> It&#39;s registered, updated, and the key file is copied to the C drive :-) programs...<br><br> When I plug the stabilizer into USB, I don&#39;t get a connection.<br> Only works if USB is plugged in, software is open, and the helicopter is disconnected from power and then reconnected.<br><br> Not ideal, but it&#39;ll do in a pinch. Just a side note.<br><br> My problem:<br><br> Channel assignment!<br><br> It is not possible to freely assign all channels in the Neo software.<br> The receiver is an RSat 2, everything is updated and set to UDI, output PPM.<br> I have several VBars, UDI works with Jeti on all of them, and I configured the channel assignment the same way I did with the Neo.<br><br> I selected a new setup; according to the description, the receiving tab should open automatically.<br> He doesn&#39;t! Never mind, I keep pressing and I&#39;m in the recipient tab.<br> Select UDI and want to adjust the channels.<br> Channel 1 motor works, also roll and pitch, bank switching... everything is fine.<br> But channel 7 should be the tail; I can enter 7 and confirm, but when I move the tail stick, nothing happens in the bar.<br> When I move the pitch stick, the beam moves from the rear with it!<br> If I disconnect the stabilizer from the power supply and restart it, the channel assignment is no longer as I specified.<br> Then Nick and Heck are on channel 3, and Aux 2 and 3 are suddenly on channels 9 and 10.<br> I have assigned channel 5 to Aux 2 and 3, but this channel is not assigned in the transmitter and Aux 2 and 3 are not being used.<br><br> How do I get the channel for the rear to be set to 7?<br><br> I also changed the channel to 8 in the transmitter, specified software 8, and nothing changes.<br><br> I need your help.<br><br> Regards, Christian","note":"machine-translated from German"}