{"ok":true,"content":"Paprika1972 wrote:<br><br><br> &gt; &gt; Info 2:07 Rescue has been started<br> Info 2:07: Motor switch was set to OFF<br> Warning 2:08 The Cyclic Ring is active<br> Warning 2:08 Strong vibration<br> &gt; &gt; Critical 2:08 Roll Sensor is outside the<br> &gt; &gt; Measuring range<br><br><br> No, I didn&#39;t start the engine during the flight.<br> &gt; switched off! Only when everything was lost.<br><br> But the log says something different...<br><br><br> At a height of approximately 10 meters, this happens very, very quickly.<br> &gt; when a helicopter goes upside down and then positions itself<br> &gt; Pitch is coming. ;-)<br><br> That was the background to the question of calibration.<br><br><br> And one more thing... if you overdrive the Neo<br> &gt; then the rescue is aborted, and that&#39;s what it says.<br> &gt; then it&#39;s also in the log! Mine shows nothing. Therefore, I...<br> I didn&#39;t overdrive it!<br><br> true<br><br><br> I didn&#39;t have time for that at all...<br> The transmitter was definitely set up correctly... it did.<br> &gt; Several flights and rescues worked.<br><br> Is every bank set up correctly?<br><br><br> I am truly unaware of any wrongdoing and<br> I&#39;ll stick to that...!<br><br> We don&#39;t want to find someone to blame, but rather get to the bottom of the reason, right?<br> Unfortunately, humans are one of the biggest sources of error, even if nobody (including me :-\/ ) wants to admit it.","note":"machine-translated from German"}