{"ok":true,"content":"DJBlue wrote:<br> -------------------------------------------------------<br> &gt; Info 0:42 Motor switch was set to ON<br> &gt; Info 0:45 Increased vibration level<br> &gt; Info 0:55 Increased vibration level<br> &gt; Info 1:04 Increased vibration level<br> &gt; Info 1:13 Increased vibration level<br> Warning 1:22 Strong vibration<br> &gt; Info 1:59 Increased vibration level<br> &gt; Info 2:07 Rescue has been started<br> &gt; Info 2:07 Motor switch was set to OFF<br> Warning 2:08 The Cyclic Ring is active<br> Warning 2:08 Strong vibration<br> &gt; Critical 2:08 Roll Sensor is outside the<br> &gt; Measuring range<br> &gt;<br> &gt;<br> &gt; First off: Looks like you have serious<br> Vibration problems.<br> &gt;<br> &gt; You pull the emergency button mid-flight and do in the<br> &gt; equalize the engine for a second. Then you hit the stick.<br> &gt; How crazy (rescue is therefore aborted) I<br> &gt; because the helicopter falls and falls and falls until it<br> &gt; hits.<br> Um, is the transmitter set incorrectly? At the motor switch?<br> &gt; arrived?<br> Was the Neo rescue performed on a horizontal surface?<br> &gt; Calibrated\/zeroed?<br><br> The rescue system was calibrated on a level surface! And it worked several times...!<br> I think it was only about 10m and you can&#39;t say for sure whether the helicopter had just hit the ground or whether the engine had just stopped.<br> No, I did not switch off the engine during the flight! Only when everything was lost.<br> At a height of about 10 meters, things can happen very, very quickly if a helicopter flips upside down and then gives positive pitch. ;-)<br> And one more thing... if you over-steer with the Neo, the rescue is aborted, and that&#39;s recorded in the log! Mine shows nothing. Therefore, I didn&#39;t over-steer!<br> I didn&#39;t have time for that at all...<br> The transmitter was 100% correctly configured... it worked for several flights and rescues.<br> Vibration problems can occur very quickly with a 450 Rex... This can happen even during more aggressive flying. And if the Beast had no problem, then the Neo should be able to handle it too. The Beast is much more sensitive to vibrations. But even during the dry run in the software, they never exceeded 20%! And the stabilization software clearly states that it shouldn&#39;t exceed 60%. I was far from that!<br><br> I am truly unaware of any wrongdoing, and I stand by that!","note":"machine-translated from German"}