{"ok":true,"content":"Service report submitted!<br> Well, thank you for taking care of this, and I sincerely apologize for being a bit over the top... at least regarding the headline, and some sentences might not have been expressed quite right. I was just really, really angry.<br> I&#39;ve also tried to make it clear several times in the other forum that my intention wasn&#39;t to badmouth the stabilizer itself or the support. Okay, phone... things are really bad with you guys...!<br> And yes, I have to admit that I didn&#39;t ask any questions here in the forum or try to contact anyone by email! That&#39;s because I kept getting answers to my questions in various forums and ultimately managed to get it flying. And if the helicopter hadn&#39;t crashed during such a rescue attempt, I probably would have been happy with the stabilizer, because it flew great! I&#39;ve never had such a well-functioning tail on my Rex 450 L!<br> But what good is all that if everything works perfectly, but the helicopter is destroyed precisely because of a function that&#39;s supposed to save it in certain situations? Now I have a Neo that I don&#39;t want to install anymore because I&#39;ve lost all confidence in it, and a completely wrecked helicopter.<br> Of course, you have to pull yourself together a bit to avoid going ballistic. I flew this helicopter with the AR7200BX (Spektrum Beast) at least 50 flights without any problems. And then you install a system that was intended for the Goblin 700 in the 450-size helicopter, just to test it. And what happens...?! The helicopter is wrecked after just a few flights... and not because I crashed it, no, because I deployed the rescue system to test if it worked properly! You&#39;re pretty dumbfounded when the helicopter is lying on the ground. Main gearbox shot... tail shaft, rotor, and boom... bent... All three swashplate servos are gone, and we don&#39;t even need to talk about the head and canopy. So, almost a total loss... And then you don&#39;t even know why!<br> Yes, that annoys me.<br> Also because I didn&#39;t just start tinkering haphazardly in this regard, but rather configured everything correctly. I&#39;m pretty sure of that! But oh well, I&#39;ll see what happens.<br> In the worst case scenario, I&#39;ve thrown a lot of money out the window!<br><br> We&#39;ll wait and see until then!<br><br> I hope I was able to calm things down a little and we can start again from scratch.<br> Because I can&#39;t apologize any more than I already have for my tone.<br><br> I hope that this will at least be understood correctly now.<br><br> Regards<br><br> Thomas","note":"machine-translated from German"}