{"ok":true,"content":"Guys... be careful with the Neo... with the rescue device...!<br> After much deliberation, I switched from Beast to the new Vstabi Neo, and that was probably a mistake.<br><br> I finally got everything set up and was pleased that the stabilizer was working so well. I performed several rescues, and with my last battery... I thought I&#39;d give it another push while hovering, and suddenly the helicopter flipped upside down and crashed. That was my first experience with Vstabi... That&#39;s it for me. I&#39;m furious... Absolutely livid!<br><br> I had to struggle long enough to figure out the settings... especially when using a third-party transmitter, in my case a DX9, you&#39;re pretty much at a loss until you know what needs to be adjusted. The manual is more than meager, and everything you need to know can only be found in the forum or elsewhere. I was much happier with the Beast. This foray into a different (=Mikado) corner of the market was a real lesson for me. I don&#39;t want to be a beta tester again, and nobody&#39;s going to compensate me for the damage! Shaking my head.<br> I&#39;ve been searching everywhere for a mistake I might have made, but I can&#39;t find anything for the life of me. The fact is, the helicopter had several flights without any problems, and I also tested the rescue system multiple times without issue to familiarize myself with it! Even upside down several times and during various maneuvers... right in the middle of a loop, for example. I was really impressed with the rescue system and didn&#39;t think anything of testing it again in a hover, and then this happens. Well, I&#39;ll post in the Vstabi forum too. Let&#39;s see what they say, but I suspect I&#39;ll be stuck with the bill. Luckily, I didn&#39;t install the Neo system directly into the 700-size Goblin.<br><br> So be careful and only perform rescues at a sufficient height during tests.<br><br> P.S. I&#39;m not alone with this problem... <a href=\"http:\/\/www.helifreak.com\/showthread.php?t=696167\" target=\"_blank\" rel=\"noopener noreferrer\">http:\/\/www.helifreak.com\/showthread.php?t=696167<\/a><br><br> Regards<br><br><br><br> Edited 3 times. Last edited on 15.08.2015 at 13:12 by RV.","note":"machine-translated from German"}