{"ok":true,"content":"I now have Master connected to ESC and Slave to AUX-2 and the motor is starting up.<br> However, after 1-2 seconds it then reduces its speed (estimated at the head to be about 1 RPM\/sec, so very slowly).<br><br> I also noticed that the orange wire is cut out of my slave BEC line - I don&#39;t remember why that was necessary back then - the helicopter is over 5 years old.<br><br> The 3-position switch on the left side of the transmitter, where I have my 3 speed settings (throttle curve) of 46%, 59%, and 64%, has no effect, meaning no increase in speed. In the transmitter&#39;s sub-trim, I had to increase the value from 0 to 71 for the motor to even start \u2013 at 70, there&#39;s still no response.<br><br> It can&#39;t be much more...<br><br> Greetings<br> Stefan","note":"machine-translated from German"}