{"ok":true,"content":"Hello everyone,<br><br> Barely new and already a question. I&#39;m experiencing the following issue: I converted my Voodoo 400 to Neo and wanted to use the Neo&#39;s RPM control. So I replaced the existing ESC with the YGE90LV. I&#39;ve been flying at 1500 \/ 1700 \/ 1900 RPM and would like to continue doing so. Unfortunately, the lowest achievable RPM is just over 1800 (it varies slightly). 1900 RPM can be set. The software is set to 1500 \/ 1700 (or 1900) RPM for each bank, but these values aren&#39;t being reached, and the display shows approximately 1800 RPM, which I also measure using an optical tachometer.<br> The translation is set correctly.<br> What&#39;s striking is that this speed is exactly at 70% throttle opening on my RPM calculator.<br> Is it possible that the Neo&#39;s throttle setting doesn&#39;t go below 70%?<br><br> Just to be on the safe side, I&#39;ve already ordered a smaller sprocket with which I should be able to reach 1500 rpm at 70%...<br><br> To the helicopter<br> Pyro 400-14<br> 14-tooth sprocket<br><br> all of this on 4S<br><br><br> Best regards<br> Ronny<br><br><br><br> Edited once. Last edited on 17.08.2015 at 20:04 by romikado.","note":"machine-translated from German"}