{"ok":true,"content":"Failsafe for AUX2 and AUX3 only works in conjunction with VBar Control?<br> I&#39;m currently playing with a third-party channel and NEO without LINK, but nothing happens on AUS2\/3. Am I doing something wrong?<br><br> I attached a servo to AUX2\/3 for testing purposes.<br> And in the setup, the throttle channel is assigned to AUX2\/3. However, when I disconnect the receiver from the NEO\/or switch off the transmitter, nothing happens at 2\/3.<br> The servo connected directly to the receiver goes into failsafe mode (when I switch off the transmitter).<br> The failsafe indicator light becomes active in the PC software.<br><br> wolfgang<br><br><br><br> Edited once. Last edited on 18.08.2015 at 01:24 by ikarus991.","note":"machine-translated from German"}