{"ok":true,"content":"Hi Uli,<br><br> many thanks for your response.<br><br> The rescue mode is set up correctly. It&#39;s assigned to a momentary action switch and is always off. It only activates when the switch is toggled on rescue mode. I don&#39;t use the beginner mode.<br> The rescue system was successfully tested on several consecutive flights.<br><br> Failsafe outputs the following: Motor OFF \/ -100. All other channels 0 (All servos neutral. Rescue OFF. Bank 2)<br><br> This, in combination with the error log, definitely explains the different mode switches.<br><br> The loss of reception led to:<br> Engine off<br> Bank 2<br> Reception is back:<br> Bank 3 (This was the active bank at the time of receipt)<br> Engine On<br><br> My reaction to the seemingly uncontrolled helicopter:<br> Engine idling<br><br> What I don&#39;t understand is the rescue, but I could have accidentally touched it.<br><br> Therefore, I will look for the fault in the receiver\/antenna.<br><br> Best regards","note":"machine-translated from German"}