{"ok":true,"content":"Hello everyone,<br><br> I had a crash yesterday with my 450 T-Rex.<br><br> Let me tell you how I remember it.<br> I went flying. What I noticed during this flight was an unusually low engine speed. I was a little surprised, but I continued flying.<br> While I was in a backward hover, the helicopter suddenly tipped over into a roll.<br> I immediately pulled the throttle hold (programmed as idle on my system) and watched as the helicopter fell to the ground from about 3 meters.<br><br> Damage pattern:<br> 1 DFC arm broken (could this be the reason??)<br> Slight deformation of the rear axle due to the crash and damage to the hood.<br> Everything else is fine.<br><br> What doesn&#39;t match the experience is the VBar log file.<br><br> This shows that I supposedly made all sorts of mode switches in the same second.<br><br> Therefore, here is my question.<br> How can I explain that?<br><br> The logs more or less coincide with the crash in terms of timing (milliseconds instead of seconds in the log would certainly be helpful here).<br><br> Could this have happened during the crash?<br> Should I check the connection between the receiver and the stabilizer, or replace the receiver and the cable to the stabilizer as a precaution?<br><br> The Vstabi Neo is connected via the Futaba S-BUS protocol. The latest firmware is installed.<br><br> After rebuilding the mechanics and conducting some tests without rotor blades on the table, everything behaves normally again.<br><br> Thank you for your contributions. File attachments:<br> <a href=\"https:\/\/www.vstabi.info\/forum\/file.php?53,file=19739,filename=log-Absturz.zip\" target=\"_blank\" rel=\"noopener noreferrer\">Open<\/a> | <a href=\"https:\/\/www.vstabi.info\/forum\/file.php?53,file=19739,filename=log-Absturz.zip,download=1\" target=\"_blank\" rel=\"noopener noreferrer\">Download<\/a> - log-crash.zip (877 bytes)<br>\n                    \n                ","note":"machine-translated from German"}