{"ok":true,"content":"Personally, I&#39;ve already put this issue behind me. Well, I was just at the flying field and adjusted the throttle channel endpoints in the ESC II menu on the Forza transmitter (the one with the Vstabi installed) because my soft start wasn&#39;t very smooth. Once I was finished adjusting it, I simply disconnected the helicopter&#39;s power and unplugged the USB connector. Then I reattached my propellers and plugged in the battery. After that, I wanted to do my pre-flight check and pushed the pitch lever up. The helicopter immediately started spinning and smashed my transmitter case. Luckily, no one else was hurt. If you have the &quot;Pitch on Throttle Channel&quot; option enabled and disconnect the Neo transmitter, then plug the helicopter back in later, the Neo is back in exactly the same position when you plug it in. This didn&#39;t happen with the regular Vstabi, and frankly, I don&#39;t think it&#39;s acceptable. It&#39;s extremely dangerous!<br><br> Regards, Manuel","note":"machine-translated from German"}