{"ok":true,"content":"Hello Mikado Team,<br><br> My club colleague Matthias M\u00f6cks built a 435 tandem helicopter.<br> For testing purposes, I took the NEO from my Logo480XX and played around a bit with the macro cells.<br><br> Here&#39;s the maiden flight:<br> <a href=\"https:\/\/youtu.be\/u5v4zU4DlqA\" target=\"_blank\" rel=\"noopener noreferrer\">First flight of the 435 tandem RC helicopter prototype M\u00f6cks435T VBar NEO<\/a><br><br> Technical specifications for the first flight:<br> Takeoff weight: ~5100g (including training frame which weighs approx. 450g)<br> Rotor diameter: 100cm<br> Hull length: 96cm<br> Hull width: 6.4 cm<br> Height of top edge of rotor: 38cm<br><br> Stabi: VBar NEO VLink 6.1 Pro Rescue<br> Broadcaster: VBC<br> Motor: Align BL600MX 1020kv (actually a bit too big\u2026)<br> Sprocket: 11 teeth<br> Main gear: 118 teeth<br> Controller: Kontronik Koby 55 LV (will be replaced by YGE 90 LV v2 due to the BEC)<br> Battery: SLS 6S 5800mAh (without training frame it will be a lighter ~4500-4700mAh)<br> TS servos: 6x Sav\u00f6x SH1250MG<br> Telemetry: IISI<br><br> IISI Log from the first flight:<br><br><br> A few photos:<br><br><br><br><br><br><br> The NEO and the VBC are really awesome!<br><br> So, now I have a few questions...<br><br> The most important thing first, before ordering:<br> The designer wants to fly the helicopter with his Jeti transmitter, RSat2 UDI and NEO <strong>non VLink<\/strong> , which in principle should not be a problem (thanks to helifuzzy <a href=\"http:\/\/www.vstabi.info\/forum\/read.php?53,133876,136286#msg-136286\" target=\"_blank\" rel=\"noopener noreferrer\">http:\/\/www.vstabi.info\/forum\/read.php?53,133876,136286#msg-136286<\/a> ).<br><br> To program the macro cells in advance with my VBC, I need to connect a VBC satellite to AUX2 and AUX3. No problem there either <a href=\"http:\/\/www.vstabi.info\/de\/node\/1960\" target=\"_blank\" rel=\"noopener noreferrer\">: http:\/\/www.vstabi.info\/de\/node\/1960<\/a> .<br> After setting the macrocells, the VBC satellite can be disconnected again, and the remaining settings can be made via the software.<br><br> However, I use AUX2 and AUX3 as servo outputs in the Maco cells for the rear swashplate.<br> Can AUX2 and AUX3 be programmed as servo outputs in the macro cells on a non-VLink NEO with a connected VBC satellite? Or does my colleague need to order the VLink version of the NEO for this?<br><br> greeting<br> Christian<br>","note":"machine-translated from German"}