{"ok":true,"content":"Hi Ulrich,<br> I&#39;m not experiencing the immediate termination issue with two helicopters when triggering the rescue in a hover position. The pitch correction doesn&#39;t stop, not even after the initial two seconds. On the workbench, the pitch correction decreases, even when simulating a tilted helicopter. After two to three seconds, the rescue ends and the pitch returns... or perhaps those two to three seconds feel longer than they actually are in flight. I actually counted and stopped at four seconds.<br><br> If the helicopter is rescued from a tilted or inverted position, then it is correct that the pitch adjustment stops after the rotation.<br><br> I understand the landing procedure. Here&#39;s the test sequence.<br><br> Helicopter on the ground, function check, also rescue<br> Take off, hover, rescue, helicopter pulls up and straightens<br> Flying for several minutes<br> Back in hovering position, brief hovering<br> Call for help<br> Heli pulls slightly to the left<br> Repeated testing, helicopter always pulls to the left<br> Land, check if it&#39;s the same on the ground, nothing to see, take off again.<br> Floating<br> Rescue is being pulled, helicopter is currently pulling upwards.<br><br> It&#39;s fine that it doesn&#39;t go into a hover; there&#39;s no active braking, I&#39;ve read that. But here, I&#39;m not getting any speed.<br><br> Could you perhaps actively test this? Or could another pilot reading this thread do the same?<br><br> -Torsten","note":"machine-translated from German"}