{"ok":true,"content":"Hi Eddi,<br> So the NEO is installed on the designated plate on the Joker, where the VBar used to be. It&#39;s a sturdy aluminum plate between the chassis plates. Nothing will twist there :-)<br><br> It&#39;s installed horizontally, glued to the original pad, so nothing should shift. The cable is routed with a little slack, but not so much that it can constantly flap around, nor so tightly that it pulls on the stabilizer bar.<br><br> I calibrated the rescue function. I leveled the helicopter precisely on both sides using a scale and then calibrated it. It worked for a while, but after 8-9 minutes of flight, it shifted slightly. After landing and restarting, without switching it off, it was OK again. In my opinion, this indicates that something is drifting on the horizon. As I said, nothing dramatic in my case, and a potential rescue would have worked, but if it shifts, couldn&#39;t it shift further?<br><br> Yes, I&#39;m familiar with the interplay between DZ and damping, especially with paddle helicopters.<br> I&#39;ll try the even lower DZ (Dynamic Level) setting. With my bailout DZ at 15%, there&#39;s no wobbling :-) I&#39;ll try lowering my previous value by 5%.<br> But I&#39;m already pleased that lowering the I-value was the right approach.<br><br> greeting<br> Torsten","note":"machine-translated from German"}