{"ok":true,"content":"Hello,<br> I finally started using my Joker 3 in the NEO era today :-)<br><br> So far, I&#39;m very happy with the tail stabilizer. I previously had a VBar Blueline installed and was satisfied with it. The NEO is even a touch better in terms of stabilization; the helicopter stays in its position, even in windy conditions, with very little drifting.<br><br> I&#39;ve already tested the rescue function, at least while hovering and during some loops... you have to practice that :-)<br><br> I noticed two things.<br> - When you pull the rescue button while hovering, pitch is applied. This pitch increase isn&#39;t reversed, not even after 2-3 seconds, even though it should be after 2 seconds when the rescue function automatically disengages.<br> I flew my program for one battery charge without using the rescue function. I wasn&#39;t doing any wild 3D maneuvers, just a leisurely circuit with the occasional loop. Then I used the rescue function again while hovering. I noticed that the helicopter pulled slightly to the left. Not much, I&#39;d say about 5 to 10 degrees max. I repeated this 2-3 times, same effect, always pulling slightly to the right, always by the same amount. I then landed and tested the rescue function on the ground, no lateral movement was visible. I took off again, hovered, used the rescue function, and it just pitched straight up. Does the &quot;artificial&quot; horizon change after some time? I set it during the initial setup.<br><br> I don&#39;t consider either of them critical, but I&#39;d like to hear the developer&#39;s opinion on this :-)<br><br> And another tip for optimization. I like to fly at low RPMs. During my first flight, I experienced a slight wobble at my lowest RPM that still worked with the VBar, I think around 2Hz. I then changed the integral value in the TS menu, 40, 60, 80, and found 40 to be the best, but the wobble wasn&#39;t completely gone. In the end, I increased the RPM by a few percent and the wobble disappeared.<br><br> Are there any other parameters or tips to eliminate this behavior without increasing the engine speed?<br><br> Thanks and regards<br> Torsten<br><br><br><br> Edited once. Last edited on 21.08.2015 at 00:15 by toddiebandit.","note":"machine-translated from German"}