{"ok":true,"content":"Hello,<br><br> Yesterday I had my first flight with the Goblin 700 Comp. and the new Neo (without VBC - with SBus receiver).<br><br> The helicopter flew perfectly - since I like to &quot;push the software to its limits&quot; (which I have also done with the Silverline so far ;-)) it&#39;s now time to optimize the Neo to my personal flying style and my personal preferences.<br><br> And I have a few general questions about the meaning and effect of individual parameters:<br><br> 1.<br> New parameter &quot;Heli size&quot; in the main rotor expert tab - this parameter was not available before:<br> What exactly does this parameter do?<br> What value should be set for a 700, or within what range of values?<br> For example, what specific effect would it have on the flight characteristics if I entered 50 and then 100 for a 700-size helicopter?<br><br> 2. Pitch Pump:<br> The tooltip explanation states: &quot;Sensible value 30..60 (active)&quot;.<br> Is Pitch Pump not active at all with a value between 1 and 29, and only activated from 30 upwards, or does the addition of Pitch Pump occur almost linearly within this value range, meaning: the proportion increases (consistently) as the value rises? (even with a value below 30)?<br><br> 3. Uneven rear pirogues:<br> The tail pirouettes are not performed quite evenly, i.e., one half of a pirouette is performed slightly faster than the other half.<br> Can I improve this behavior by increasing the &quot;I-share&quot; value for the tail rotor?<br> Within which range of values is an adjustment of the I-component meaningful?<br><br> 4. Stop Gain:<br> In the latest SW version (6.1.7), the labels for the two values (A and B) are now available.<br> Is it still the case (as before) that the A-value describes the stopping behavior from a right pirouette (= tail control stick to the right) and B from a left pirouette?<br><br> That&#39;s all for now - thank you in advance for the (expert) answers!<br><br> vg,<br> Tom.<br><br><br><br> Edited once. Last edited on 28.08.2015 at 09:04 by tluckeneder.","note":"machine-translated from German"}