{"ok":true,"content":"What you see on the ground is simply the time the integrator needs to enter the working area. This only applies on the ground, because in the air the tail section follows and is therefore always within the working area.<br><br> The software itself hasn&#39;t changed in that respect; the working area depends on the sensitivity setting, hence the difference.<br><br> There shouldn&#39;t be any noticeable hesitation during acceleration. Could it be that the rear end is a bit overwhelmed, perhaps benefiting from more power in the form of longer blades? Or higher engine speed?<br><br> So long... Uli<br> <a href=\"http:\/\/www.vstabi.de\" target=\"_blank\" rel=\"noopener noreferrer\">http:\/\/www.vstabi.de<\/a>","note":"machine-translated from German"}