{"ok":true,"content":"A flight with another helicopter confirmed that the rescue button works without any problems.<br><br> A test run without leaves showed no abnormalities. The rescue operation was only performed when the button was pressed.<br><br> What I also noticed during the tests without blades is that the governor overshoots by up to 400 RPM when the pitch input is applied without a load. If you hold the input for several seconds, the target RPM stored in the bank stabilizes. Then, when you return to 0 degrees pitch, the RPM drops by up to 400. I suspect this behavior is due to the lack of load, but it could also explain the drop in the log.<br> Is this governor&#39;s behavior normal?<br><br> Regards,<br> Hermann","note":"machine-translated from German"}