{"ok":true,"content":"Soooo<br><br> Unisencs - E gives me the same RPM reading....<br><br> The rear end is now holding up well enough.<br> The controller sensitivity is now set at 1700 rpm and 2000 rpm.<br> at 5 :-)<br><br><br> 1700 - Tail is a bit unstable, spins out slightly at full pitch<br> 2000 - Rear end rotates very slightly \/ less than at 1700 rpm<br> 2300 - Holds perfectly.<br><br> Now I&#39;m going to fly two poles and see what time tells me.<br><br> I was actually hoping to get it down to around 8 minutes...<br><br><br> I might start a separate thread about the rear-end problem so that the errors can be explained and the solution shared.<br><br><br> Greetings Tobias","note":"machine-translated from German"}