← Logo 400 ... 690

Mikado Logo 600 im Vario Airwolf Rumpf Übersetzt

Mikado Modellhubschrauber › Logo 400 ... 690 · Von Sky1 am 22 Februar 2023 16:3322.02.2023 16:33 erstellt
Sky1 22 Februar 2023 16:3322.02.2023 16:33
Hi everyone!

I have gotten my hands on a Vario Airwolf "mini", which is smaller than the current available Airwolf range from Vario. And as it sits, the Mikado Logo 600 sits there very comfortably! A "boy's dream" coming true.

All up weight expected to be 4.2kg. I'll be flying on 6S 5.000mA at low RPM (just enough to hover at about 5 degrees pitch) and test flights have confirmed this should be fine. I'm getting 5+ minutes hovering to 3,80v/ cell with a 1.5kg additional load. Motor's cool, ESC is cool.

So, there are three things I have to figure, if at all possible (if not, so be it).

1) The Airwolf should have a counter-clockwise main rotor system. I am considering to buy a freewheel, get the bearing out and replace it with a suitable bearing. Is this doable? And, would the main gear need to be turned upside down or would it be fine as is.

2) The rotor distances (mid-shaft) should be about 76-78 cm but my Logo has a longer tail boom, making a rotor distance of about 86 cm. Is it possible to knock off some distance and get a slightly shorter belt? If so, which one and what would the rotor distance become?

3) I want the belt to be "floating" in the fuselage, regardless of rotor distance. My intention would be not to put the tail boom in the mechanics. I would glue in a 15 cm carbon Mikado 25mm tail boom way in the back of the tail of the fuselage. The original did not have a tail boom either. I'm just curious if the boom would be able to handle the compression of the tail boom (anti-torque is fine).


Many thanks. My favourite scale helicopter combined with my favourite mechanics!!
Eddi E. aus G. 22 Februar 2023 16:5922.02.2023 16:59
Hi,

1) it' fine with that bearing, but you'd need to flip main gear and pinion, too, so it pushes the teeth.

2) please find the different lengths available here: https://www.vstabi.info/sites/default/files/Masse.pdf maybe one of these booms fits better?
Looks like you'd have to decide between 740 (too short) and 810 (slightly too long) mm.

3) never tried. But either the carbon or the aluminum should still hold the clamps, if you mean that.

Kind regards

Eddi

Born to fly ...
forced to work.



Edited 1 time(s). Last edit at 02/23/2023 08:48AM by Eddi E. aus G..
Sky1 22 Februar 2023 19:3422.02.2023 19:34
Thank you Eddie!

I'll go ahead and experiment with the OWB!

Thank you for the link, i'm saving that to my harddrive! But rather longer, I'll see to 3D print an extension for the tail cone. It doesn't look awful but it's just a bit longer. "Purists" will condemn my choice, probably.

Exactly, just that last bit of tube to maintain strength and have the clamps of the tail mechanism to hold.
VStabi VStabi Pioneer of Flybarless