← Logo 400 ... 690

Demontage der Taumelscheibe mit Logo für Wartungszwecke Übersetzt

Mikado Modellhubschrauber › Logo 400 ... 690 · Von Rappytappy am 15 Februar 2024 22:3315.02.2024 22:33 erstellt
Rappytappy 15 Februar 2024 22:3315.02.2024 22:33
My swashplates need their bearings replaced. It is many more times cost effect to simply replace the bearing than replace a entire swashplate that is in perfect functioning condition otherwise.

I have an arbor press, heat gun and can craft any jigs necessary, but I've been pondering how this thing is put together, but doesn't seem like other swashplates I've serviced in the past in which the upper swash is a two piece unit that screws together to hold it to the swash bearing.

So basically, how can the upper part of the swashplate be removed from the lower part the correct way without damage?

Edit: This is for the older Logo 550 thinner swashplate, not the larger 690 type swashplate.



Edited 1 time(s). Last edit at 02/15/2024 10:43PM by Rappytappy.
Eddi E. aus G. 16 Februar 2024 09:2416.02.2024 09:24
Hi,

I'm not sure, and I have never disassembled one, but I guess it's as simple as a press fit, maybe with help of some bearing glue.

So theoretically, if you can get a grip and/or a pressure point, without risking damage to the softer aluminum part, you should be able to get it apart, with help of some heat ... or cold, actually, since the aluminum part should shrink more than the steel bearing.

Kind regards

Eddi

Born to fly ...
forced to work.
VStabi VStabi Pioneer of Flybarless